MythTV Reloaded - Day 15
I've done a bit more research into this remote control thing and found a couple of commands to use for debugging. First is ir-keyboard. If I run ir-keyboard with no options it will show me what device is found, what protocols it is capable of and which one( it is using. In my case the output looks like:
Found /sys/class/rc/rc0/ (/dev/input/event5) with:
Driver imon, table rc-imon-mce
Supported protocols: RC-6
Enabled protocols: RC-6
Repeat delay = 500 ms, repeat period = 33 ms
In addition, I can run ir-keyboard -t and it will put the IR receiver into test mode. Every time I press a button on the remote it puts up the codes and key names that it decodes. According to this, everything it being seen properly and should be working. I guess it's just an issue with the handoff to LIRC that's the problem. I'm a step closer but still confused...
Again, I can say that the hardware is working fine and it's a software config issue that's holding me back. Now to figure out what that is...